No products in cart
How to connect my plasma power generator to the small cutting machine
- SteelTailor
- Connect with plasma power
- 0 comment
Q:- How to connect my to the CNC small cutting machine.
A:- There are six wires to connect between plasma and CNC.
START:-2 wires
FINISH:- 2 wires
ARC+:- 1 wire
ARC-:- 1 wire
Refer your manual for details for connection
| Signal | Type | Note |
| CNC START | output | Normal open: dry contact closure; used for torch ignition. |
| CNC START | ||
| DIV ARC+ | Input | Receive the signal of raw arc voltage from plasma. Can receive the arc voltage from 50VDC to 300VDC. |
| DIV ARC- | ||
| DIV FINISH | Input | Normal open: dry contact closure; Receive the signal of OK TO MOVE from plasma; it is the signal sent by plasma source to CNC machine, to give the feedback that the torch is well ignited and ready to move. |
| DIV FINISH |
Our service team will help you connect any plasma model to the SteelTailor CNC
You can contact the service team via email:- This email address is being protected from spambots. You need JavaScript enabled to view it.
Also contact us via Skype: service-steeltailor
Add new comment
